The Ultimate Guide - Operation Steps of Spring Tension Tester.

 Hey! Today, I'm going to give you a detailed introduction to the operation method of the Spring Tension Tester. This is really a super cool and practical machine, produced by Mikrosize Company. Mikrosize is a well-known enterprise that has long been committed to providing high-quality testing equipment, and this Spring Tension Tester is one of their top products.

First of all, let's take a look at the machine itself. The Spring Tension Tester of Mikrosize is designed very user-friendly, but like any equipment, it must be used correctly. When you first get the machine, be sure to place it on a stable and flat surface. This is extremely important. Because if the machine shakes during the testing process, the obtained results will be inaccurate.

Next, let's talk about how to turn on the machine. There is usually a power switch on the side or back of the machine. Flip this switch, and you can see the control panel light up. The control panel is the key part. On the control panel of the Spring Tension Tester, you will see a bunch of buttons and a display screen.

Before the test, you need to set the parameters first. There are special buttons for adjusting the force range. For example, if you are testing a small and delicate spring, you need to set a lower force range; if you are testing a large and heavy-duty spring, you need to set a higher force range. Just use the "+" and "-" buttons to adjust according to your needs.

Then, you need to install the spring on the machine. The installation mechanism designed by Mikrosize is very simple. There is a clip at each end of the test arm. Open the clips, carefully place the spring in the middle, and then clamp it tightly. Be sure to ensure that the spring is in the center position and firmly fixed. If it is not done properly, the spring may not be accurately tested, and it may even fly out during the testing process, which can be very dangerous.

Once the spring is installed and the parameters are set, you can start the test. There is a large "Start" button on the control panel. Press it, and the machine will start applying a pulling force to the spring. As the spring is stretched, you can see the data on the display screen. The screen will show the magnitude of the applied force, the elongation of the spring, and other important data.

During the testing process, pay attention to the situation of the spring and the machine. If you notice any abnormalities, such as strange noises, or if the spring looks like it is about to break in an unexpected way, immediately press the "Stop" button. This is a built-in safety feature of the Spring Tension Tester of Mikrosize, which can prevent any accidents from happening.

After the test is completed, the machine will stop automatically. At this time, you can record the data from the display screen. After that, open the clips and remove the spring. If you have more springs to test, just repeat the above steps.

That's it! Once you understand the steps, operating the Spring Tension Tester of Mikrosize is not difficult. Just remember to carefully follow these instructions, and you can get accurate and reliable test results every time.